This module provides basic power protection for the modular carrier boards.

Add-on module for Auvidea carrier boards (JNX30M, JNX42, JNX42P).

• Common mode filter (improved EMI)
• DC power in: 19V max (4A nominal)
  • reverse voltage protection: highly efficient with MOSFET
  • 18V TRS diode for protection against over voltage spikes (>20V)
  • The voltage limit of the carrier board still applies, this board does not reduce...

Power over Ethernet (power input)

Add-on module for all Auvidea carrier Boards with a 22 pin FPC PCIe X1 connector on the bottom side. Adds powering via the Ethernet connection and enables the use of a M12 X-Code connector. 72W peak power is intended for the use with high power systems like the Orin NX. Please reserve a certain margin, to allow peak power draw by the Jetson. Also please account for the power requirements...

Power over Ethernet add-on module (power input)

Add-on module for Auvidea carrier boards (JNX42P) to add powering via the Ethernet connection. 72W peak power is sufficient for high power Orin NX systems. Please reserve a certain margin, to allow peak power draw by the Jetson. Also please account for the power requirements of peripherals like SSD, cameras and more.

• PoE++: 802.3bt Type 4
• Isolated PoE++ module: Murata...

Power over Ethernet (power output)

Add-on module for Auvidea carrier boards (JNX30M, JNX42 and more) to deliver PoE power to network cameras. The P18 integrates a pushup power supply, to boost the 12V or 24V input to 48V for PoE. This eases the integration of PoE into 12V and 24V systems.

• PoE+ power control: manage PoE connection, check power draw, enable/disable power
• PoE control: TPS23861 (control and status via I2C)...

Power over Ethernet add-on module (power input)

Add-on module for Auvidea carrier boards (JNX30M, JNX42 and more) to add powering via the Ethernet connection. 25W peak power is sufficient for mid range Jetson systems (Orin Nano). Please reserve a certain margin, to allow peak power draw by the Jetson. Also please account for the power requirements of peripherals like SSD, cameras and more. For high power Orin NX systems...

This add-on board is necessary if you want to use PoE PSE on the J142-12 carrier board for the TX2.

It boosts the power input of the carrier board to 48V, which are required for PoE PSE to function.

The J143 is available in 2 configurations:

J143-12:

– power in: 12V to 48V
– PoE PSE requires 38360 PoE boost add-on module

Changes from J140 to J143:

– J143: 2x USB 3.0 with TX2 (J140: 2x USB 2.0 with TX2)
– J143: M.2 NVME x2 (J140: M.2 NVME x4)
– J143: up to 48V (J140: up to 12V)
– J143: PoE PsE