Size: 18mm x 16mm
2x 2.2mm mounting holes
Power supply: 3.3V or 5V
2 outputs
2 inputs
Usage: UART or GPIO level shifter

Ideal for JNX30, JNX30M, JNX42, etc:
– UART0 port (J25)
– I2S port (J26) – please check pin direction
– etc

Please note that some descriptions of pinouts on the bottom side are wrong. The correct pinouts are as follows (you can also use picture 3 as guidance):

UART 3.3V:

• GND
• CTSin...

Tiny adapter to interface Framos CSI-2 camera modules with Auvidea carrier boards (with voltage and interface conversion)

HDMI to CSI-2 bridge (ships with 50mm 22 pin FFC cable (0.5mm pitch) and a cable set for the 10 pin connector) (38127-2) (only for Raspberry Pi Zero)

CSI-2 adapter for Allied Vision Alvium cameras

• 22 pin CSI-2: to connect to Auvidea carrier boards (0.5mm pitch)
• 22 pin CSI-2: to connect to Alvium camera (0.5mm pitch)
• 12 V power (4 pin JST-GH – locking)
• recommended input voltage range: 6V to 12V
• absolute maximum input voltage: 13.2V
• overvoltage input voltage protection with TPSMA6L12A TVS diode
• onboard 12V to 5V DC converter (up to 5V 3A) to power the Alvium camera...

The B112 is a compact HDMI 2.0 to CSI-2 bridge (4 CSI-2 lanes @ up to 2 GHz).

It features a HDMI 2.0 input (600 MHz and 6 Gbit/s) for 4kp30 @ 10 bit color (4:2:2) and 4kp60 at 8 bit color (4:2:0).

It is based on the Lontium LT6911UXC.

It has the same physical size as the B102 (27 x 42 mm) but supports HDMI 2.0 and 4k modes.

Driver is now available for download on Github.
It will be shipped out untested.

The B112...

The B210 (38253) interfaces the Tamron MP1010 LVDS camera to the TX1.

This module is FPGA (Spartan-6) based and potentially be adapted to other LVDS sources.

The B210 features a LVDS interface with 30 pin KEL connector to connect to Tamron (MP1010M-VC) or Sony block cameras.

Resolution up to 1080p30.

A driver for the Jetson TX1 is available.

Size: 32.5×53.5mm.

Note: compatible only with Jetson TX1.

This product is EOL,...