These systems let you dive into AI with ease. They are configured to allow you to explore AI applications like people detection, face masking and more.

The full suite of NVIDIA SDKs is installed. 3rd party applications demonstrate the full potential of the NVIDIA embedded edge solutions.

At you choice these systems can be equipped with the entire family of NVIDIA compute modules with the SO-DIMM form factor.

The JNX30...

The JNX400 is a quad carrier board for the Jetson Nano, TX2 NX or Xavier NX.

The key application are inferencing use cases in low energy data centers.

Any mix of compute modules is allowed. The master manages 3 slaves with control (console UART) over power up, reset and flashing (USB). The power supply is optional.

If there is no stock, the lead time may vary. For more information, please contact...

HDMI to CSI-2 bridge (ships with 50mm 22 pin FFC cable (0.5mm pitch) and a cable set for the 10 pin connector) (38127-2) (only for Raspberry Pi Zero)

The Nano/NX to TX2 adapter is an add on module for TX2 carrier boards.

With this adapter board you can plug it on a TX2 carrier board and run a Jetson Nano or Xavier NX on it.

The X400 (38441) is lightly larger as AGX Xavier compute module (90mm x 100mm).

Components are just on the top side.

SD Card reader and buttons are option on the bottom side.

Features:

• 12V Power input on PicoBlade connector
• 1x HDMI out, 2x micro USB 3.0, 2x GbE on PicoBlade connectors, 1x M.2 Key M NVME PCIe x4
• USB 2.0, CAN0, FAN, UART3 and I2S/I2C are located arround the board on PicoBlade connectors

The JNX33-PD is a compact carrier board for the Jetson Xavier NX (and Nano). It supports the MAXN mode of the Xavier NX and adds CAN and PCIe x1 (compared to the JN30).

A special feature is the PoE PD function, meaning that the JNX33-PD can be powered by power over ethernet.

The JNX33-PD is also available as low cost version (JNX33-LC-PD). The JNX33-PD version adds powering by PoE from a network switch (PoE-PD: 802.3at) and...

Jetson AGX Xavier carrier

• 2 x GbE
• 2 x USB 3.0
• 1 x USB 2.0
• 1 x HDMI out
• M.2 NVME PCIe x4
• optional: up to 2x LM823 Wifi modules
• UFS/SD card
• UART
• I2S/I2C
• Extension port for PCIe x4/x1/USB/UART/GPIOs
• Extension port for CSI-2 (for up to 8 cameras)
• Safety MCU for AGX Xavier Industrial (please see manual for details)
• wire kit

The barebone system includes: JNX30 carrier board, passively cooled aluminum case (135x109x50mm), leaf spring, heat spreader and mounting material. With a small NRE charge the front plate may be customised.

If there is no...