Description
Technical details of the JNX30D development system:
| Description | JNX30D |
| power in | 6V – 19V (5.5/2.5mm barrel connector) |
| Xavier NX powering | 5V 8A power supply (over current LED) |
| HDMI | yes |
| FAN connector | yes |
| M.2 NVME Key M | yes |
| M.2 Key E | only with external module (using internal USB) |
| micro SD | yes |
| USB 3.0 | 1x USB 3.0/3.1 (native – full performance) |
| micro USB | 1x micro USB (device or host mode) |
| Auto Flashing | yes (plug in host cable and flash) |
| USB 2.0 | USB 2.0 (JST-GH) |
| Ethernet | Gigabit RJ45 (2 LEDs) |
| CAN | RX and TX (requires CAN transceiver) |
| PoE option | no (optional on other models) |
| MIPI CSI-2 | 2x CSI-2 (4 lanes) plus camera LED (hardware sync available) |
| UARTs | console UART and user UART |
| GPIO header | 40 pin plus 8 pin with I2Cs, UARTs, SPIs, I2S and GPIOs (uni-directional and 5V tolerant) |
| Crypto chip | for software copy protection and licensing |
| Size | 80×104.6mm – flat bottom, no components on bottom side |
We also have an enhanced version of the JNX30D carrier board with components populated on the top and bottom side.
Only available on request.
▪ IMU
▪ board EEPROM
▪ PCIe x1 connector
▪ LM823 WIFI module
▪ 2 more CSI-2 interfaces (2 lanes each)
▪ RTC battery (rechargeable)
▪ over current fuse (product safety)
▪ UPS option for graceful power down
▪ on board MCU for watchdog and remote power cycle (LTE)